Diam.Trac, 1103 Model

	Quick Change Exchange, LLC Phone (562) 696-4020 / Fax. (562) 696-9801 (E-Mail)


	"New" QCE Diamond Trac-V DT-531P-1103 (Model 1103)

This One Really Works

1/7/08

Replacement Parts List
ILL.	Part Number	Description	Net Price
1.	DT-1	1/2"-20 x 1.1/4" Rt. End Bolt	$4.19
2.	DT-2	1/2"-20X2" Lt. End Bolt	$4.83
3.	DT-2X	1/2"H.T. Washer for Above Bolts	$0.96
4.	DT-3	1/4"-28 x 1/4" Set Screw	$0.96
5.	DT-4	Wear Plate (Right)	$9.29
6.	DT-4A	Wear Plate (Left)	$9.29
7.	DT-5	3/4" Dowel Pin	$6.12
8.	DT-6L	Pinion Gear (Left)	$30.68
9.	DT-6R	Pinion Gear (Right)	$30.68
10.	DT-8	Right End Housing, Aluminum	$107.32
11.	DT-9-K	Coil Spring "Kit " (16) For G9	$40.90
12.	DT-9A-K	H.T. Steel Insert "Kit" (32) For G9	$38.28
13.	DT-10	Center Spring , Old Style (1) For Type III	$7.49
14.	DT-14-1103	Gear Body (Steel) "1103 Model"	$252.81
15.	DT-12	Left End Housing, Aluminum	$202.44
16.	DT-20L	Axle Gear 31-spline (Left)	$73.72
17.	DT-20R	Axle Gear 31-Spline (Right)	$73072

19.	DT-14	Gear Body (Steel) "G9 Model"	$222.73
	DT-14-1103	Gear Body (Steel) "1103" Model	$252.81
Total Labor To Overhaul Any QCE Diamond Trak In Any Condition $45.00

Part Number	Net Price
DT-531P-1103	$873.06


	1. Loosen set screws holding 1/2" bolts. (Lube when re:installing.) 2. Remove 1/2" bolts. From both end housing. (Lube when re:installing.) 3. Remove right end housing first, this end has (2) 3/8"-16 threaded jack bolt holes if you need them. 4. To remove left end housing use a soft mat"l. hammer on upside down axle gear to knox off left end. 5. Remove all parts, clean real good, inspect all parts very good. You need to see when you are looking. (Look for chiped or cracked gears) replace as needed. 6. Wear Plates can be turned over and reused if you think they have excessive wear. (If cracked or broken replace) 7. Re:assemble all parts, install left end first TORQUE 1/2"-20 bolts on right end (lubed bolts) to 70 - 75 ft.lbs, left & right ends. 8. Note: make sure you have all the springs you are going to use & the steel inserts 2 per spg., install them after left end has been assembled. 9.Use a good quality high temp grease on all moving parts when ready to assemble. Use grease on the spring ends to hold the steel inserts in place during assembly.